Camera mount on top of a VESA monitor
Description
This mount is designed to hold your DSLR, mirrorless or any other camera or video equipment on the top of a computer monitor. This way you can use it for video conferences, streaming etc. without a need of a external camera stand. The only requirement is that your monitor should be compatible with VESA 100x100. The mount is adjustable, I have tested it with three monitors: 22", 27" and 32", but please make sure it will fit to your monitor before printing. Instructions: 1. Print one element 1, one element 2, two element 3 and two element 4 pieces (PLA with 20% infill is fine) 2. Get two M4-20, two M4-18 and two M4-16 screws (or similar) and a set of nuts and pads 3. Get one 1/4" screw to lock camera on the top 4. Connect loosely element 1 with two pieces of element 3 and with element 2 using M16 screws as shown on a pictures 5. Connect loosely element 4 pieces with element 2 using M4-16 screws as shown on a pictures 6. Use M4-20 screws to replace your original VESA screws, mount element 1 to the monitor 7. Adjust a construction and tighten all screws 8. Mount a camera, quick release plate or any other equipment to the top of construction using 1/4" screw.
Statistics
Likes
0
Downloads
0