ErgoPlay clone for classical guitar
Description
This "knee stand" for classical guitar is modeled after the [ErgoPlay Tröster](http://www.ergoplay-shop.de/epages/62022937.sf/de_DE/?ObjectPath=/Shops/62022937/Products/EP80004/SubProducts/EP80004). However, I do not have access to an actual ErgoPlay, so this was done off the top of my head with no actual measurements. Additional items needed: 1) 2x Wing nuts / bolts / washers to attach the actual supports to the knee brace. 2) 2x Suction cups to be attached at the top of the curved supports where they contact the guitar. Holes will have to be drilled for this. 3) The knee pad 'cushion' that is on the bottom of this design is intended to be printed in TPU, as that's softer material. Alternatively, you can omit printing that part and glue on some proper foam for support.
Statistics
Likes
0
Downloads
0