CGC Graded Card / Slab Necklace
Description
Note: This is specifically for CGC Graded Card slabs. Tested on graded cards from CGC on May '22. I don't own PSA or BGS or other graded card slabs. So, I can't say it's universal. Feel free to re-mix this to make it compatible with other vendors' slabs, just attribute the original design idea to me. I was inspired by "The Logan" necklace on Etsy, however, I wanted to make my own and make it easy to print. Printing: Be sure to print with a soft plastic material such as normal PLA or even softer material such as TPU 95A (not tested) or something similar. You don't want to end up harshly scratching the graded card slab. Warning: USE AT YOUR OWN RISK, I WILL NOT BE RESPONSIBLE FOR SCRATCHES ON YOUR GRADED CARD SLABS. Installation: Slide and hook the graded card slab under the top tab of the slab holder and press down firmly, the sides should bend slightly, and then the slab should be securely installed. You may or may not scratch the side of your slabs depending on how hard the plastic is that was used to print the slab necklace. USE AT YOUR OWN RISK, I WILL NOT BE RESPONSIBLE FOR SCRATCHES ON YOUR GRADED CARD SLABS. Materials: 1. Sand Paper (to sand down sharp edges) 2. Good performing Crazy Glue (to secure the top portion to the main slab holder necklace) I used Loctite Super Glue 3. 2mm line/rope for the necklace to secure around your neck Recommendation: 1. I recommend testing out with a slab where you don't mind scratches on the side of it (ie. a low graded/non-expensive card). 2. Use a soft see-through plastic sleeve over the graded card slab for a more snug fit. Be aware, The SOFT PLASTIC SLEEVE WILL BE RUINED after installation due to the tabs that keep the slab in place (it will pierce through).
Statistics
Likes
0
Downloads
0