Yongnuo YN360 Ground Stand
Description
This is a floor stand for YN360. Please note, that it only works for the square body, not the round body YN360. I found it annoying that no matter what stand I use, the YN360 would always be at least 80cm high. Then I designed this, which basically places the lamp ON the floor which is rather handy with such a high but thin lamp. It´s completely one print and screwless. The fit is tight enough to lift the lamp without the stand detaching. I am using 10.000mAh batteries and it has no issues holding the lamp (no falling over) Printed on an AnycubicMega X (300x300mm). Please print as an "x" not a "+" (see images) because otherwise it wont fit on the printbed. You can print with high speeds (60mm/s+) and a rather thick layer height (0.25mm+). I recommend high temps when printing fast (+-220°C) and using "exclusive fit" in your Slicer to make sure it fits nicely
Statistics
Likes
0
Downloads
0