Unregulated "Mod" Case With Heatsink
Description
I made this for my DIY unregulated mod kit. I couldn't figure out what to do because the transistor got hot really fast and melted the plastic, verified wiring was correct. SO... I made this to hold it all, its a very tight fit and loosely holds a "usb lithium ion charger" I cannot tell you how to assemble it because I will not be responsible if you blow yourself up. specs of heat sink: 40mm x 21mm x 8mm I pulled it off a random power supply so I can't give a link the center of the screw is 4mm from the top of the heatsink The screws I used to hold the lid on are standard PC screws robbed from a Dell Optiplex. For printing I used supports it's hard to remove but worked well for me. the circular holes don't need support they printed fine in PLA without it (have not tried other materials)
Statistics
Likes
0
Downloads
0