Small Table Catapult
Description
A small catapult that was inspired by a <i>thing:1763518</i> I found out that that thing tends to break in half and lose a lot of springyness. So I made myself a custom small catapult (and some low-cost ammo as well) It's made from two parts which you just combine together (better if glued) Printed as a small rectangle. <b>Printer settings that I found as just fine:</b> (classic PLA) - layer height: 0.2mm - wall thickness: 1mm - infill: 15% - top/bottom: 1mm - NO supports - Adhesion type: skirt / 3 lines / 3mm (build 2+ sets in different colors with different color ammo for the most fun)
Statistics
Likes
0
Downloads
0