(WIP) Sturmmörserwagen 606/4
Description
Hello Everyone! I am going to be inactive for few months as the computer I have been using to 3D model belongs to the school I was attending. I am graduating so I am required to return it back and my own computer has been broken for a while. This will be my last "pack" for a while until I can get another computer which may be in a few weeks to months. This pack is highly incomplete but I'll just shove this out there just so some of you can enjoy it. Essentially it has a sturmtiger with a traversable turret and openable hatches. (Do note that a solid non-traversable turret version will be included once I get a computer again.) IMPORTANT: Once the gun is inserted, it cannot be pulled out! This also likely does not work with anything smaller than 1-100 scale. so be patient in when I upload the solid versions Assembly goes as follows 1. Insert the gun mount into the chassis (Put inside, push hard until the ball clicks into the slots) 2. Aim the ball mount opening upwards at about a 45 degree angle 3. Take the gun and turn it sideways (The pegs on the sides should be horizontal) 4. From the front of the chassis, insert the rear of the gun as far down as you can go into the gun ball mount (Ensure the ball mount opening is pointing at an angle upwards) 5. Once all the way in, twist the gun into the correct orientation (The pegs of the gun should be sitting on the rear of the ball mount) 6. Once in the correct orientation, align the pegs with the slots in the rear of the ball mount, then pull as hard as you can. The gun should slip into place. 7. Test gun movement. 8. Place roof. 9. Place hatches (It should sit on top, not fit in tightly)
Statistics
Likes
0
Downloads
0