No-Slip Tool Holder
Description
No-Slip Tool Mount. This is my first version of a tool (rake/shovel/broom) mount, that when you slide into place, pinches in on the tool and holds it up. This version can be made without any other screws etc (aside from the screw to mount it) There are 2 pegs protruding from the base layer, both are identical. One side is for the round "bumper" and the other side is for the "pad". you will print 1 of each of these pieces, you will then print off 2 of the pins and they slide in place to keep the Pad and Bumpers in place. I was actually able to use this without gluing it successfully, but i would recommend adding the glue once you know where its going. I printed the Bumper and Pad in Siraya Tech Tenacious (Obsidian Black). SO its a flexible resin and i printed those pieces with 2mm walls and 16% infill so they had a little flex in them. I printed the rest of the parts in a standard resin (Siraya Tech Fast - Grey). So if you try this with filament, you may want to try TPU for those parts.
Statistics
Likes
1
Downloads
0