Solder Station TS100
Description
Thanks to sunbart for this https://www.thingiverse.com/thing:2814811 Modifications: Extended iron tip holder as it doesn't get that hot and the copper is not really needed Changed the bearings mount to use 10mm bearings Changed the axle roller to suit roll of solder and available 10mm bearings (bearings screw into roller) Note. I used very old "wood effect" PLA which I have loads of but It is a little brittle . The solder dispensing upright broke off at the base. I super-glued it together using 2 lengths of piano wire as re-bar inside the square infill.
Statistics
Likes
0
Downloads
0