Picture hanger with clip
Description
Original design. Simple. *STORY* We had a bunch of picture hooks that were visible above the picture frame. I made these to slide down over the nail but remain hidden. I added a 45 degree bevel on both sides, this should prevent a picture which slides to the side from falling off the wall. But there are lots of earthquakes here, so I also wanted to ensure the hook stayed on the nail, so I made a clip that can slide up from the bottom. Pretty tight tolerances, but should be able to slide on by hand. If you need a looser fit version, let me know. Or a shallower version. *PRINT SETTINGS* I printed them in PLA at: - .20mm layer height - 20% infill - 2 perimeters. (3 perimeters should make them mostly solid. I will update this if pictures start falling off my walls, lol) I will add photos later. Of the problem I was trying to solve and the result of these models. Installed 10 so far, about to print 3 more, so I will take a picture of them after being printed and on the wall.
Statistics
Likes
0
Downloads
0