Creality CR6 CR-6 SE Breakout Board Cover Taller, with Base and Optional LED Strip mount for 40mm Part-Cooling Fan
Description
I remixed my remix to improve on the design. This one is taller (goes further down), has a base and positions and angles the LED strip better. It still includes the cut-out for a 40mm fan, but this one interferes with the bed sensor less. I used a warm-white cob LED-strip, but you could also use the cheapest white LED strip you can find and it would be a bit brighter, but less of a spread. You WILL need to print with supports for this. I updated the fillet on the front top to be a chamfer, so really all you need supports for is the two "ears" that the mounting screws go into if you print in the model orientation. I printed in PTFE just in case it gets warm and for the extra strength. Don't use bolts longer than 9mm to mount this to the hot-end cable connector or they will push the connector outwards and make it wonky. I used even smaller M3 bolts to mount the LED strip mount (I cut all the bolts to be the perfect length with a hacksaw). There are lots more images in my posted make.
Statistics
Likes
0
Downloads
0