Bluetooth Case Finger Grips
Description
Forever having an issue opening my smooth Bluetooth earplug case, I wiped up a quick finger grip design and added them to the case. I went from hardly using it because of the problem I had opening it to using it every day. First draft wasn't tapered an was a bit too tall. Oh well, they were already glued on so the pictures show the originals with a utility knife modification. The download file is the proper design. Heat them up a bit to soften, pre-fit them to get the correct curve of the case (I would dot a facet so you always know the orientation) and put on a just the smallest amount of epoxy (clean off any squeeze out). I secured mine with some tape until dried and then done!
Statistics
Likes
0
Downloads
0