Razer Tartarus Throne (Gamepad Ergonomic Stand)
Description
I wanted a really high angle, more than what was offered on any other site; this one stands just shy of 3.5 inches. It is perfect in my opinion. This was made to be the most efficient (speed and as little material as possible) stand while retaining maximum strength. I only test printed it at .4mm with PLA as is no supports on a Flashforge Adv 3 and it came out PERFECT so you should be able to print no issue! I printed a prototype before polishing up the design that you see here. I will post pics of my functional prototype later. It helps to remove the grip material under the Tartarus wrist side (the largest pad) and cut thin strips off the sides of it for the bottom of the stand (three spots worked for me: two near each long side corner and one in the middle of the small end) and a couple strips where the gamepad makes contact with the stand. Just put any excess non slip padding back on the device where you got it and rock and roll. Works for me great!
Statistics
Likes
0
Downloads
0