Revopoint Pop2 turnable wobble fix
Description
This help to greatly reduce the wobbling that occur due to weight distribution. Strongly recommend a plastic that support heat so it does not deform in hot environement. Abs and Petg will work fine. I printed mine with transparent petg, 240°C Bed 85°C, layer height 0.3, infill 100%. Used Layer ironing for top layer only in a concentric line pattern at 0.1 line spacing with 8% flow. No need for glue. Just put a few spot of grease under it so it stick in place and on the other side add a thin coat where bearing will roll
Statistics
Likes
0
Downloads
0