Sasuke Kusanagi Sword - Naruto Shippuden
Description
Complete Overhaul of Techna_Animas' amazing design. I wanted a design file exactly how it is in the anime, where the handle and the scabbard matched flush. I liked the handle design of Technas the most so I went with his design as a base. What I did to his design: SWORD - Widened the blade to 32mm - Reduced the thickness of the blade to 8mm. (flimsy but support rod keeps it strong) - Reduced the male pegs on each connection by 8% so they're not as snug - Widened the handle to 40mm - Included a 4mm hole through the sword, for an 1/8" support rod - Added an additional blade segment to get a full sized sword. SCABBARD - Modeled it from the handle file, so the scabbard matched flush with the handle - The blade hole is 5% larger than sword (largest I could fit). Fits snug at first, after sanding the blade it fits perfectly. I'm not sure about painting, paint may rub off the blade. -Included 2 - 4mm holes for 1/8" rods. Helps line up pieces for gluing and is much stronger than printed pegs. ASSEMBLY To get a full sized sword and scabbard you will need to print: - Handle 1 - x1 - Handle 2 - x1 - Blade Tip - x1 - Blade Middle - x4 - Blade End - x1 - Scabbard Mouth - x1 - Scabbard Middle - x4 - Scabbard End - x1 You will also need to purchase 3 - 1/8" steel rods (cut to shape when assembling). Available at most hardware stores, about $5 ea. Each part took an average of 4 Hours to print, total print time is about 56 Hours. The only parts I used supports for were Handle 2 and Scabbard End. I orientated the rounded ends on the print bed.
Statistics
Likes
0
Downloads
0