Bowden Tube Cap
Description
A simple cap designed to fit snugly over the end of a Bowden tube with the intent of sealing them closed. The hope is to keep air and dust from getting in to an otherwise sealed filament dry box. Specifically sized to fit over Capricorn tubes but should work for most tubes including stock Creality tubes Cura tries to be nice and scale it up so you might need to scale it down to 50% or 51% depending on how wide the outer diameter of your tube is. The total size should be 6mm wide and deep by 11mm tall. Should only take about 10 minutes to print depending on your settings and 0.07m of filament. Just make sure it's 6mm x 6mm and you should be good to go
Statistics
Likes
0
Downloads
0