Magnetic MicroSD Case
Description
### A magnetic case for 12 MicroSD cards This case prints in 2 parts on any printer, and uses 2 magnets (glued with super-glue) to keep it closed and keep your micro-sd cards organized and protected. You will need two round magnets with a 15mm diameters and 3mm thickness (smaller magnets should work too). Features: - Prints on any FDM printer with no supports, no raft, and standard settings - Magnetic lid is easy enough to open with one hand, but won't open in your bag - Fits 12 micro-sd cards, accounting for the possible variation in their dimensions between different manufacturers (mainly in thickness) - Slots are shaped according to the cards, so that cards can only fit in 1 way, to keep them organized and consistent - Spacing between cards is designed for easy access - A large MicroSD logo on the top cap for easy recognition - Built in clearances for easy assembly and a satisfying fit Instructions: 1. Print both parts with their flat faces facing down (the logo requires minimal bridging and does not need supports) 2. Use super-glue (5 second glue) to attach a magnet into the round slot in the center of both parts and allow glue a few minutes to dry 3. Insert your microsd cards with the contacts facing down, and the notch facing inwards
Statistics
Likes
0
Downloads
0