CAM ANCHOR CLAMP FOR BOAT
Description
This is a cam clamp for fixing the anchor. I use it on a small inflatable boat with a 2.2kg anchor. Rope 8 mm For assembly, you will need 2 bearings 608, it is better to use a modification closed from dust and moisture. 2 bolts with nuts m8 with drilled bolt tips. I also used a simple spring with an inner diameter of 22mm + . I bit off 3-4 turns and unbent the ends of the spring, one end into the hole in the bolt, the other end was melted into the cam with a soldering iron, immediately above the bearing. I did not print the substrate, I cut it out of a sheet of caprolon I'm sure you'll figure it out
Statistics
Likes
0
Downloads
0