LED Triforce
Description
This is a remix of https://www.thingiverse.com/thing:2472946/files My changes are as follows: I redesigned the door to mount a D1 Mini (ESP8266). Added a hole for a 4mm usb cable and 3 posts to wrap cable around for pull strength and a small loop to secure wires under. Another major change, which isn't very obvious, is the CENTER piece. I could not get the original to print as there are over hangs inside and outside (that print mid-air) to accommodate the corners. I did not want to print the open side down and need lots of support (time and filament wasted). So i simply changed the inner walls leading up to the opening, to a 45degree angle. Print this with the opening facing UP...and the only support you need are on the bottom (to support the overhang for corner lip) I used a .24 Z-spacing. It supported VERY well and came off easily. I scaled ( https://www.thingiverse.com/thing:3004171 ) this down to fit on the flat face. I used a D1 Mini (esp8266) along with 16 WS2812B (4 per corner) leds with WLED loaded (https://install.wled.me/ link to installer) onto the D1 Mini and a standard 5v 1a charging block for a cell phone.
Statistics
Likes
0
Downloads
0