Knob for Micro Swiss Direct Drive Extruder
Description
I love the look of pixel2's extruder knob, but as designed it does not fit the Micro Swiss extruder I installed on my Ender 5 Plus as the “stem” part is too thick and is obstructed by the tension gear pivot. I did this very simple remix to make it fit properly. I don't know for sure but I suspect this fits most Micro Swiss extruders, at least those with the 8mm drive gear. Prints without supports, low infill (20% or so) seems fine. Combined with my Filament Runout Sensor upgrade (link below), this makes unloading and reloading filament way easier than I thought possible. Filament Runout Sensor Upgrade: https://www.thingiverse.com/thing:5398548 NOTE: The photo makes it look like the knob is touching the tension gear pivot, but there is actually 2 or 3 millimeters of clearance.
Statistics
Likes
0
Downloads
0