Karl's Lily58 Keyboard Case
Description
A case for the Lily58 Pro Keyboard with optional tenting. Supports cherry and choc hotswap sockets. Keyboard installation instructions: * If not yet built, the keyboard should NOT be installed with standoffs or the backplate (the case will be your backplate) * If already built, you can remove the backplate and brass standoffs (you might need to shake the boards a bit to remove the screws under the keycaps). Remember that there are FIVE standoffs in the big holes, all must be removed. * Press the keyboard down into the case. You might need to wiggle it a bit until it is secure. * If you wish to travel with the keyboard, you may consider sticking the keyboard to the case using tape. Optional Standoffs: * The case comes with 5 optional standoff fixings (three on the inside, two on the outside) * If you wish to have tenting, you will need some M3 bolts and nuts to thread through the holes. In the images above I am using 70mm bolts with two nuts per bolt (one above the fixing hole, and one below to keep it secure) * The case is perfectly usable without the tenting supports installed, however if you wish to entirely remove the fixings around the edge, you will need to edit the model.
Statistics
Likes
0
Downloads
0