Binocular Tripod Mount for Swarovski EL 8.5 x 42
Description
Remix of "Parametric Heavy Duty Binocular Tripod Mount" to specifically fit Swarovski EL 8.5 x 42 binocular. It is wider than the original file and I offset the nut hole for better balance. I round the edges slightly from the original to prevent scratching of the binoculars. I would suggest printing in PETG rather than PLA, with the file oriented exactly the same as the STL with the face of the C flat on the print bed. I used 0.15 layer height. I used 4 perimeters and 50% gyroid infill for extra strength. This file requires a 1/4 size 20 nut. I was a very tight fit. I had to hammer the nut into place.
Statistics
Likes
0
Downloads
0