CR-10 V3 Better Spool Rig Alternate
Description
This is just a Remix of my better spool holder for the Creality CR-10V3, It is the same top mount as my last one just runs with one arm and a longer spool roller. For the minimalist out there that wants less parts to print and half the time to print this one. Its main focus (on both designs, was to fix the horrible angle the stock spool fed into the runout sensor. I also made a low profile mount that can go along with this print, but is not necessary. though it does make more clearance for changing spools. check it out here; https://www.thingiverse.com/thing:5418544 this uses only two 5/16" bolts with nylock nuts 1" Long for the arm, and an 1 1/4" for the roller use M4 x 10mm bolts and Tee nuts for mounting (I only use 5/16 because I have a lot laying around, equally M8s with the proper length in mm would most likely work as well if you of the metric persuasion) Unlike my other design, run the rollers' bolt with the head facing inside
Statistics
Likes
0
Downloads
0