Stoeger XM1 S4 Barrel Band and Probe Plug
Description
A barrel band for the Stoeger XM1 S4 4,5mm air rifle and a plug for the fillport on the air cylinder. The barrel is "free-floating" in the end, so it doesn't take much to move the barrel which can happen with the rifle in a case. Then the rifle looses it's accuracy and has to be resightet. Before printing, check the distance between the barrel and aircylinder, the barrel band got a 1mm distance and if there's a too large gap i don't suggest adding the barrel band since it bends the barrel. Warning. This will most likely void the warranty! In order to attatch the barrel band, you have to remove the stock from the trigger assembly/barrel/aircylinder group. Then unscrew the screws holding the barrel (under the scope) and the barrel band in the middle. Press the barrel band over the aircylinder just under the fillport. Put the barrel through the other hole and it should slide though and into the barrel holder just under the scope. Screw everything back (remember which screws goes where, some are different) and attatch the stock and scope.
Statistics
Likes
0
Downloads
0