Ender 3 v2 PTFE-Coupler Strain Relief Clamp
Description
This Coupler Clamp makes sure your Stock PTFE-Coupler does not wear out on the Ender 3 v2 stock extruder! Printing: * 3-4 perimeters * No supports Installation: * Remove the PTFE-Tube from the Coupler if it's already installed * Make sure the the flat sides of the PTFE-Couplers hex drive point sidewards so the clamp sits horizontally on the coupler * Attach and fasten the clamp using a cable tie * Use a piece of sanding paper to push in the PTFE tube firmly through the clamp and fully into the PTFE-Coupler,the fit is very tight * Use another cable tie to tighen the clamp onto the PTFE-tube FreeCAD Source files are included.
Statistics
Likes
0
Downloads
0