Foghorn Leghorn Tail Pin Redux
Description
I couldn't get the default pin to work correctly because of a bit too much squish on my tail pieces, and rescaling the pin was changing the relative placement of the elbows compared to the tail channels, so I just cut off all the elbow sections so that it should be easier to scale and fit inside. Printing this at 100% scale is exactly like printing the default tail pin, just with the elbows cut out. I ended up printing this pin at 98% and it was a snug fit, but after some convincing with a mallet it fit in beautifully.
Statistics
Likes
0
Downloads
0