Anycubic Mega LED Strip Retainer
Description
These 150mm strips firmly hold WS281x (or any 12.2mm wide) LED strips to the Mega X gantry (or any edge that's 1.45mm thick, with 9mm+ available depth, and with 1.6mm+ clearance behind. No adhesive is needed as the strip is retained by its edges (leave the wax paper adhesive cover on, or you will make it difficult to install). There is adequate clearance for the bypass capacitors on some strips. The front hold-down clips provide an additional 4 or 7mm of effective shading at the front, depending on whether the shade is at the front or the back. I printed mine in white, and that works very well with OctoLapse. For Mega S or Mega Pro, six pieces each is adequate, but make seven holders if you want to miter the two top corners. 150mm long, and they easily snap to length... Designed in FreeCAD.
Statistics
Likes
0
Downloads
0