Satsana with CR Touch for Aquila X2
Description
Printed another remix with a mount like this, however, it would not fit my CR Touch, so I adapted my own. I just adapted my bracket design to be one piece with the cooler. I also took the liberty to go inside the Satsana and curve the inner wall for the left side air duct. Don't know if it'll do anything, but, when working with air ducts I'd prefer there to be round corners instead of hard corners. You can see this in the pictures. You can check this in your slicer by going through the layers. **I currently have not printed it as of 7/19/22 and I will update it after doing so.** ### Hardware Holes for the CR Touch are designed for M3 Screws & Nuts like my CR Touch Bracket ### Probe offset: -50, -15 *I'm sure it's not perfect, but it's fairly close.* Will take measurements after print ### Print Settings See below **Please leave comments and such with any issues you have!**
Statistics
Likes
0
Downloads
0