Dual 4010 Fan Shroud
Description
Dual 4010 Fan shroud. Designed for my Creality CR10 printer. Also fits my Lottmaxx. Will fit many other hotend setups that share this general Chinesium design. I printed in PETG for long term heat resistance (I'm sure it would be fine in PLA for an economical amount of use before any nozzle distortion occurred). Consider orientation and be mindful of being able to remove supports post print. I've printed multiple of these with different orientations and typically end up using a small screw driver (minor scraping inside) and needle nose plyers or decent tweezers to remove supports. If your supports are already a bear to remove, go google how to calibrate them for easier removal before attempting this print. I would not attempt this print using a support density above 12% per any orientation or post cleanup will not be fun. On a decently calibrated machine, the ten minutes of post print cleanup is well worth the upgrade. I used the stock screws to attach the hotend fan and small lengths of wire to attach my parts cooling fans. I just wired the new addition parts cooling fan in parallel with the existing one.
Statistics
Likes
0
Downloads
0