MKS Robin Nano V1.2 mounted to V-Slot for Zyltech Gear V3
Description
After making my own extruder mount, the wires were too short to go inside the bottom controller enclosure. Instead of lengthening the wires, I chose to move the controller outside the bottom enclosure. I also had to move the display to be close to the board because of the short wiring for that. Here are all the parts I used. 1 - V-Slot 2020x600mm for vertical (Cut to fit if you want) 2 - V-Slot 2020x250mm for bottom & Top Horizontals (Cut to smaller length if you like) 16 - T-Nuts 16 - M5x12mm used with all T-Nuts 4 - M3x10mm socket head screws & Locknuts to connect MKS V-Slot Brackets together 4 -M3x10mm socket head screws, 2mm M3 spacers & Locknuts to mount MKS board to mount 4 - M3x12mm socket head screws, 3mm M3 spacers & Locknuts to mount MKS Robon Nano board to mount Print 1 - M3x2mm_3mmSpacers v1.stl 1 - MKS_Robin_V10_OutsideBrdMount.stl 1 - MKS_TFT35_BlankInsideCover.stl 1 - MKS_TFT35_V-Slot_Mounts.stl 2 - OffsetCorner.stl 1 - V-Slot_Corner90_Rev3.stl (only used on bottom 2020x250mm) 6 - V2020_EndCap.stl 2 - VSlot_Corner.stl 1 - WireFrameFlatMount.stl (Optional if using direct drive extruder for wire management) There are also 4 fusion 360 files if you would like to edit this design further & one openscad file.
Statistics
Likes
0
Downloads
0