Sequential Shifter Handbrake buttonbox combo
Description
This is my design for a sequential shifter for simracing The controller board and wires https://retroactivearcade.ca/products/110-zero-delay-arcade-encoder?_pos=4&_sid=8b09b8038&_ss=r buttons https://retroactivearcade.ca/products/sanwa-obsn-24mm-orange?_pos=40&_sid=6a8250a35&_ss=r lever https://www.amazon.ca/gp/product/B07YPWG68V/ref=ppx_yo_dt_b_asin_title_o05_s00?ie=UTF8&psc=1 The lever extensions clamp around the bought levers and are fixed with m3 screws and nuts. Shifter extension is in 4 parts: 2 shaft parts that clamp together with M3 screws, a printed m16x2 screw, and a ball, the screw is used to connect the ball to the shaft. Base accomodates M4 nuts for fixation, added a version without sidewalls for convenience. Only base printing needs supports, if overhangs angle are not a problem you can just print it on the 3 button side against the bed and use support only on edges to help support the weight for version with walls, or print sideways for version without walls.
Statistics
Likes
0
Downloads
0