Door Privacy Slider for peepholes
Description
I made this little peephole cover for doors after seeing some models online that were complicated. I wanted it to be a simple straight forward design. This model consists of 3 parts: -Housing -Slider -Bracket (There is Also a STLwith all of the parts prearranged as well) Assembly Steps: 1. Slide the slider into the housing (it only goes on the right was otherwise it will look very wonky and you will likely notice). 2. Glue the bracket to the bottom of the housing as shown in the third image above. 3. Get some double sided tape and put it over your peephole on the door. Printing Recommendation: Since the model does not require much structural integrity I would use 2 shell at 10% infill for a 0.4 nozzle.
Statistics
Likes
0
Downloads
0