Lavalier Mic Stand (v1)
Description
**Hello all!** This is my `Lavalier Mic Stand (v1)` design. I am an amateur gameplay recorder. As such, I need a mic while recording videos. I made do with my headset mic for a while, but it was low quality and uncomfortable to record with. Instead of buying a new desktop microphone, I decided to use one of the many lavalier microphones I have lying around. Thus, this little stand was born! I'm still pretty new to 3D designing. That being said, the design is simple enough to print within a few hours and sturdy enough to last a good while, in my humble opinion. Although this is not my first original design, this is my first official upload to Thingiverse. I hope this project is as useful to someone else as it is for me. Enjoy! **- Nate** --- ###Notes: - The "solid" design prints significantly faster than the original cutout design. - Hardware used: **M3 12mm hex screw**, **M3 nut** - Zip ties allow for easy cable management. --- ##Shaft Dimensions: - to hinge (~10 x ~10 x ~150) mm - to top arm (~10 x ~10 x ~190) mm ##Base Dimensions: - (~75 x ~75 x ~8) mm
Statistics
Likes
0
Downloads
0