Cherry Pi III USB and XBox power box
Description
This Is A Small Box That Allows Me To Connect An Unmodified Power Plug From An Xbox 203W Psu To My Cherry Pi Delta Printer (Http://Www.Thingiverse.Com/Thing:543303). It Also Provides A Way To Turn The Psu On And Off, Either With The Switch Or By Using The Ps-On Connection On The Ramps Board, And To Connect A Usb Lead. Although Designed To Fit A Cherry Pi, It Should Also Work For Any Similar Printer That Uses 2 Rails Made From 20X20 Aluminium Extrusion And M5 T-Nuts. Update: (26/04/15) I'Ve Added 2 More Mounting Holes To Make The Box More Secure - The Extra Holes Will Only Work If The 2 Extrusions Are Approx. 30Mm Between Centres. It Can Still Be Used With Just 2 Screws. Also, The Freecad File Has Had An Error Removed By A Member Of The Freecad Forum - This Made It Difficult To Edit The Design, Although The End Product Wasn'T Affected. Update: (27/05/15) It Proved Necessary To Redesign This Box As The Xbox Psu Proved Inadequate - But It Wasn'T Easy To Change The Design In Freecad. The New Design Is Written In Openscad, And Is (Mostly) Parametrized. See Http://Www.Thingiverse.Com/Thing:851611
Statistics
Likes
26
Downloads
0