5.9 5.2 magnum Air hat
Description
Polycarbonate or good PETG should handle the heat unless you live in the desert. May be some other filaments for higher heat applications but I used Priline CFPC at 260c @40mm/s in an enclosed chamber of 120f on an Ender 3v2 Hat prints TOP DOWN with tree supports only on bed, 65% overhang should make it support the opening but not the ring. I I used 100% infill and 5 walls, I dont think you need more than 25% infill as long as you do high wall count for the body. The tube needs a 5-8 mm brim and prints standing up. same settings as the Hat but really it's like 4 walls all the way up with no supports needed
Statistics
Likes
0
Downloads
0