Anet A8 Direct drive upgrade
Description
This is a WIP direct drive upgrade for anet a8 This upgrade uses an E3D V6 hot end with the mount designed by @Jeka_tm Once I finish this project I'll throw together a BOM as of right now it just uses left over/ spare m3 and m4 screws, the original anet drive gear, i just made it mount to the rest of the toolhead and added a fan! NOTE you will most likely need to run a Bowden tube from the heatsink to the extruder to make it easier to guide filament changes.
Statistics
Likes
1
Downloads
0