Raspberry Pi Cam G-Clamp
Description
This Little Raspberry Pi Cam Stand Has A Screw Clamp Which Allows It To Be Attached To Any Surface Up To 17Mm Thick. As A Bonus, The Screw Can Be Driven From Both Ends Giving A 2 Height Position (To Get The Screw Into The Top Thread Either Remove The Front Of The Camera Case Or Drive It Upwards From The Bottom With The Screw Inverted. Take Care However Not To Push It Through Too Far As It Contacts The Top Case And May Pop It Off). This Case Was Specifically Designed To Match The Other Rounded Features Of My Disegna3D Printer.
Statistics
Likes
60
Downloads
0