Sig P320/Glock Recoil Spring Tool
Description
Remix of Glock Recoil Spring Tool by rhadsall - https://www.thingiverse.com/thing:3854714 I needed to change the spring on a Rival Arms guide rod for a Sig P320. The screws at the end of the Rival Arms guide rod did not have a hex socket, so the Glock tool would not work. It was too long to allow me to get a grip on the screw. I also changed the shape of the tool, so that it would not require support material. Yes, I'm also guilty of uploading a knob that doesn't print well. I will probably upload a new version of the case trimmer knob at some point, but I don't actually need another at the moment. I believe that this will most likely also work for M&P guide rods, but I have not tested it yet. No reason you couldn't use this for the Glock guide rods. There is very little margin of error on these. If the through hole is too large, then the tool can let the spring slip, and it will shoot through the tool, potentially injuring the user. As printed, on a calibrated printer, the hole will probably be too small. You will likely need to drill out the hole to the proper size, or adjust scaling in the slicer so that it works for your application. Wear safety glasses whenever you are compressing the recoil spring with the tool. Use at your own risk. I am not responsible for any injuries or property damage due to use of this tool or any compressed spring.
Statistics
Likes
0
Downloads
0