Naked Runcam Thumb Pro
Description
First attempt at a naked thumb pro. This saved me 11g over the mount i was using on the foxwhoop. Cam is easy to strip, just remove the screws. Note to use this mount you must clip down the battery connector and direct solder (you can add a connector further up the wire). Mount is for Foxwhoop 25 approx 13.7g without lens cover 15.9 with cover and ND filter Thumb pro no base is just the mount itself. Note both files need the SD card plate. This is attached with the two longer screws removed from the thumb pro which screw into the lens base. You need to heat the mount up to get the naked thumb inside. Note this is a first attempt. Front section is good, SD card plate needs a little work. Lens protector has not been checked as i made this after a first attempt i used while flying. It fits the SMO4k Cam ND filters. Check this before flight as you may get edges in view. Longer term i'll change this to the foxeer ones and the shape gives more options. Put ND filter on and then fit to lens. Printed with Sainsmart 65% infill 198 tip and 60 degree bed (ender 3)
Statistics
Likes
0
Downloads
0