Ender 3 v2 - rPI 3 + 3.5" Screen
Description
Modified to fit the raspberry pi 3 model, based on [this](https://www.thingiverse.com/thing:4647536) from [plapointe6](https://www.thingiverse.com/plapointe6/). It is a snug fit for the pi and the screen, I used a 3.5" XPT2046 screen. To get the PI in and out I'd recommend to start by removing the SD card and lowering the SD card slot end first. When remove it, apply some pressure on the HDMI port pushing in. After that do the same with the USB/RJ-45 ports once it's towards the corner with the GPIO pins lift up the end with the USBs.
Statistics
Likes
0
Downloads
0