single axis escapement mechanism
Description
It is more of a proof of concept, not lasting very long, you could improve things by adding a gear ratio and optimising the wind-up spring. All the cogs are on one central axis making it more compact than other designs. There is also definitely room to make the design more compact. This isn't a finalised design but it works and it's 100% worth the print. This mechanism uses a 1.6mm diameter brass rod cut into 3 separate lengths. Careful use of a heat source may be required to melt these rods into some holes. Some sanding of the teeth on the windup gear may be necessary to allow it to be wound.
Statistics
Likes
0
Downloads
0