PN532 Breakout Board Mounting Plate And Drilling Guide
Description
This Thing Contains A Mounting Plate And A Drilling Guide For The Adafruit “Pn532 Breakout Board" (Id 364). The Base Plate Is Two Mm Thick. M2 5 Mm Or 1/4″ 4-40 Screws Are Needed To Fasten The Board To The Mounting Plate. The Mounting Holes Are Three Mm In Diameter. The Holes Do Not Go Through The Lower Layer To Make It Easier To Print. You Will Have To Drill Them.
Statistics
Likes
6
Downloads
0