Disting EX OLED display bracket
Description
I designed and 3D printed this bracket to hold the secondary OLED display for the Disting EX. No soldering is needed. [Photos](https://photos.app.goo.gl/tf2mLZe4BE9tbvT7A) This version mounts at the bottom to a Eurorack rail. It is 14HP. Note it is not 1U and will not fit in a 1U slot. It does not need or use the PCB from Expert Sleepers/Thonk. But it uses the exact same OLED display from [BuyDisplay.com](https://www.buydisplay.com/arduino-2-2-inch-128x32-oled-breakout-board-display-module-blue-on-black); choose the "Pin Header Connection-4 Wire SPI" option. The bracket holds the OLED display to which you directly connect 7 Dupont socket cables. The cables thread through a slot on the back. Sockets at the other ends of these Dupont cables connect to the two jacks on back of the Disting EX (just as with the PCB). Refer to the Expert Sleepers Github page for details on the connections: [Expert Sleepers Github page](https://expertsleepersltd.github.io/hardware/1U-display-adaptor/). The two 3D printed parts require assembly with tiny screws -- 4 screws to hold the OLED display PCB to the bracket, and two screws to hold the cable routing slot on the back. Since it is 3D printed you should pre-tap the plastic holes for the screws with a tiny drill bit to match the tiny screws. I used #1- 1/4" wood screws. You are free to download and print it for non-commercial use. I plan to make a couple additional versions with the display bracket in a 3U height 14hp 3D printed panel - one with the display at the top of the panel and one at the bottom. Use this at your own risk, of course.
Statistics
Likes
0
Downloads
0