Berd Air cooling for Duet3D Smart Effector
Description
This is a Berd Air cooling for a Duet 3D smart Effector. I printed mine is polycarbonate but any heat resistant filament like ABS, ABS, nylon ... should be fine. I used some 3/32 (2.4mm) brass tube. https://www.amazon.ca/gp/product/B000BQO57M I've sone a tight fit for the brass tubes so the M3 screws should not be needed. Depending on your cooling needs, only 1 or 2 might be enough.
Statistics
Likes
0
Downloads
0