SD Holder for Profile
Description
It is a simple design, nothing complicated. I was just looking for a support for my micro sd extender adapter and that I could screw it to the profile of my printer and that it would stay at the correct angle for easy use. I searched and didn't find anything similar to what I wanted so 1 hour (yes, I like to go slow) in Fusion360 and that's it. 0.2mm layer height is enough but I did it at 0.6mm. No supports, the central part is hollow and because of the angle it does not need supports, if you have the printer well calibrated you can print it without problems. I hope it helps someone, remixes are welcome.
Statistics
Likes
0
Downloads
0