Prusa Heat bed cable protectors
Description
I made my Prusa Lack Table Enclosure and downloaded their recommended file for the heat bed cables, the problem with the piece that comes with the printer is that the enclosure is too small for the wires to stick straight out towards the back of the printer. The recommended file for the enclosure is one that is at a 60° and there is not space for wires. It just didn't feel right squishing and pinching the wires that tight. This design in the files above is a 90° angle with plenty of room for wires and I have over 15 days of print time with this design and it has worked flawlessly. Materials: This design uses the screws from the piece that is already there and 1 extra 16mm screw from your spare parts bag. P.S. If you don't have this extra screw, you don't NEED the fourth screw, its just better with it. :)
Statistics
Likes
0
Downloads
0