Moonlamp Base when using LED Strip Mount WS2812B with the ESP8266
Description
Ok... this is a beta ... the base I designed needs work and, I was so excited to post this, I did not even clean up the brim. (not the end of the world) Total Print time 1 day 20 hours.... Oddly, Cura said it would be 2.5 days COMPONENTS (not affiliate links) LED Strip: https://amz.run/5tLl (buy with 60 LEDs per meter) ESP8266: https://amz.run/5tLm Power Supply: https://amz.run/5tLn Heat Shrink Tubing: https://amz.run/5tLo (I did not own any - if you have, you can ignore this) Soldering Kit: https://amz.run/5tLq (I did not own one - if you have, you can ignore this) Jumper Cables: I did not use jumper cables, you only need three connections so I cut three pins off of the ones that come with the boards and soldered them, then soldered the wires to them using the heat shrinking tubing. Super easy to do. If I can, I am certain you can too!
Statistics
Likes
2
Downloads
0