PicoBoot Mount for the Nintendo Gamecube
Description
This is a very simple mount for the PicoBoot for the Nintendo Gamecube. The Picoboot is an amazing open source mod chip for the Nintendo Gamecube that was created by WebHDX. Here is a link to his repository. https://github.com/webhdx/PicoBoot This is a very simple easy to use mount, simple print the main body of the mount and 2 of the stand-offs. From there remove the screw put the two standoffs where you removed the screws and then place the mount on top the stand off and put the screws back in. Note, it is recommended that you route the wires for this between the two memory card slots. Also, it is recommended that you flash the pico and put the pico into the mount PRIOR to installing. Full installation guide can be found here - https://docs.google.com/document/d/1u6lO4f-eCt2BVErIpzTogfHQKYYIgL61UB5DnGAlyhw/edit?usp=sharing If you want to buy one I have some listed here - https://www.etsy.com/RockerGaming/listing/1294629839/3d-printed-picoboot-mount?utm_source=Copy&utm_medium=ListingManager&utm_campaign=Share&utm_term=so.lmsm&share_time=1661710492729
Statistics
Likes
14
Downloads
0