ubitx6_3.5nextion front panel
Description
Nextion 3.5" display panel for ubitx_V6 chassis I wanted to have a panel that fit the chassis and would allow the 3.5" Nextion display to be centered. This worked very well for that goal. The volume knob is a modification of the knob from the "uBITX Remote Head with 3.5" Nextion Screen" project on Thingiverse. It uses an M3x8 screw for the set. The display is mounted with M3x12 screws, with a nut on the inside of the panel and two M3 washers as spacers so the display is not compressed when mounted. The Raduino is not supported, except by the bottom connector. Printing was just standard settings using CURA for the Ender3 printer. I used standard quality (.2mm) 50% infill support everywhere I was able to fill the labels with white paint, but it was only marginally effective (as shown)
Statistics
Likes
2
Downloads
0