Display Cover Vsett 10+
Description
I made this display cover on the Vsett 10+ scooter due to poor readability in daylight. The cover is printed all from the PLA material, except for the buttons. You need to print from TPE due to functionality. The main part of the cover is printed to the pad to the mat, everything else as shown. It is necessary to use the support for the main part and the voltmeter cover. Use the M4x20 screws to fasten because the original screws are short. Attention! You must not stick the voltmeter cover, because it would not be possible to dismantle the cover !!
Statistics
Likes
1
Downloads
0